Pattern Updates

I make every effort to proofread, test, check and triple check my patterns before publishing. However, in spite of my best efforts, sometimes an error slips by me. Check below to see if there are any corrections listed for the pattern you are making. 

If you notice an error not listed below, please contact me at patti.pattispatchwork@gmail.com so I can correct future patterns - thanks!

I greatly appreciate your input.

PC154 Alpine Village
(added 10/17/15)
Yardage for the G lap size had been changed from 1/3 yd to 5/8 yd.

PC157 Toscana Twist
(added 03/24/22)
Page 9 step L change 98 1/2" to 95"

PC164 Starshine Beauty
(added 9/8/16)
Fabric C should be 1/2 yd instead of 1/4 yd.

PC165 Florentine Floor
(added 2/20/2015)
Instructions:
Page 2 step 2 – please change 19” to 20” and change 14½” to 13½”

PC169 Heat Wave
(added 5/21/15)
In the cutting chart, for the lap size only, for Fabric A: STRIP-R fabric: Trim fabric a scant 1/4" before 1st strip & beyond 21st strip so that you have a seam allowance on each edge of your 21-strip fabric.
Change to: STRIP-R fabric: Trim fabric a scant 1/4" before 1st strip & beyond 16th strip so that you have a seam allowance on each edge of your 16-strip fabric.

PC179 Strips of Peel
(added 9/22/15)
Page 4: j.) Slide the bottom end of #2 through the opening in #5, positioning the 2nd last melon on #5 over the 4th melon on #2 - #5 should be 12 1/2" from the bottom.

PC181 Charmed
(added 9/18/16)
Placemat & Table Runner size: Fabric A – ground, also cut 5 strips 1 1/2" x wof; cut into (126) 1 1/2" squares. The yardage requirement should be increased to 1yd.

PC185 Stacks of Presents
(added 7/24/16)
Fabrics M-P for throw, twin & queen sizes – Using the LARGE diamond template (not the wall template)...

PC190 Winter Solstice
(added 12/30/16)
Fabric 11 – lap size: ◊ Cut 2 strips 9 5/8" x wof; cut into (5) 9 3/8" pieces – cut 3 pieces diagonally from upper left to lower right (#11R) and 2 pieces from upper right to lower left (#11L).
Fabric yardage for the lap size for Fabric 2 & 11 have been modified as well: Fabric 2 was 5/8yd, now 2/3yd Fabric 11 was 3/4yd, now 5/8yd.
(added 10/26/20)
page 5 step 7 - change (5 1/2") to (6")
(added Apr. 12/2021)
page 2 Fabric 6 - change #4L to #6L

PC198 Butterfly Lattice
(added 1/5/17)
Fabric B – throw – yardage is 7/8yd, not 5/8yd.
Fabric H – both sizes – yardage is 1 1/8yds, not 1/8yd.
Page 1 – Fabric B – throw – Cut 4 strips 4 1/4" x wof; cut into (36) 4 1/4" squares.

PC199 Layers
(added 6/23/17)
Page 4: steps 1, 2, 4 & 5 - change 8 1/4" to 7 1/4".
Steps 2 & 5 – change 20 to 25, and change 52 to 54

PC205 Butterfly Beauty
(added 4/23/20)
Page 1 & 2:  Template 6 is made with 6a & 6b (there is no 6c)

PC220 Garden Gate
(added 7/8/19)
Fabrics D, E, E & G - twin size only - yardage is 3/8yd (not 1/3yd)

PC222 In the Woods
(added 9/7/2018)
page 4 – short tree diagram – change 6¼” x 1 3/8” to S4 (6¼” x 1 7/8”)

PC225 Besties
(added 5/7/2019)
Fabrics C, D & E – page 1 –
Lap size – change “Cut a total of (16) 9½” x 2½” pieces and (4) 2¼” x wofq pieces” to “From each fabric cut 2 strips 2½” x wofq; cut into (3) 6½” pieces and (6) 2½” squares. Also cut a total of (9) 2¼” x wofq strips.
Twin size – change “Cut a total of (20) 9½” x 2½” pieces and (4) 2¼” x wofq pieces” to “Cut a total of (20) 11½” x 2½” pieces and (14) 2¼” x wofq pieces”

-page 2 – step 1 – change 9½” to 11½”
-page 2 – steps 1 & 2 – change 4½” to 6½”

PC226 Glass Menagerie
(added 8/26/2019)
Page 1 Fabric C – change “Cut 1 strip 12½” x wof; cut into (1) 20½” piece…” to “Cut 1 strip 16½” x wof; cut into (1) 20½” piece…”

                             -change “Cut 3 strips 4½” x wof; cut into (1) 32½” piece, (2) 28½” pieces and (5) 4½” squares” to “Cut 3 strips 4½” x wof; join end-to-end and cut (1) 32½” piece and (3) 28½”  pieces.  From scraps cut (5) 4½” squares
 Page 3 Appliqued units – step 2 – “…applique the prepared elephant onto the 16½” x 20½” Fabric C piece…”

PC233 Solstice Star
(added 5/7/2019)
King-size only: If using fabric that has not been pre-shrunk, cut the Fabric I squares 11⅝” and cut the 7 Fabric J matching lengthwise strips 2” wide. If using pre-shrunk fabric, cut the Fabric I squares 11⅛” and cut the 7 Fabric J matching lengthwise strips 2¼” wide to include a celtic motif and a plain stripe

PC239 Mod Trellis
(added 10/7/2019)
page 3 - step 1 & 2 - change #2 Fabric K to #3 Fabric K
            - step 3 - change #3 Fabric K to #2 Fabric K

PC241 Vail
(added Apr. 10/2020)
page 4 - step 8 - diagram is incorrect - please email for a new file

PC256 Castelvecchio
(added Mar. 23/2020, to be used if your 3-panel piece of Fabric A is less than 70 1/2" long)
page 2 - step 1 - cut the pairs 18" and 12" instead of 19" and 13"
page 5 - step 15 - measure 7 5/8" along bottom edge to cut the Fabric B pairs

PC263 Hexie Crush
(added Apr. 12/2021)
T5 on page 7 should be labelled T2 (use to cut Fabrics B and J)

PC276 Hometown Holidays
(added June 16/2022)
If using the Howdy Christmas panel as shown on the pattern cover, please use the PC276A addendum in conjunction with the pattern to cut and construct your quilt.

PC287 Windblown
(added Aug. 3/2022)
page 4 - step 5 - last sentence - change "For option #2..." to "For option #3..."

PC290 Edenvale
(updated Nov 17/2023)
lap size only - page 2  - Fabric H - Cut 1 strip 3⅜” x wof; cut into (12) 3⅜” squares ⧅(H2).
Fabric I - "and 4 to 25¼” (i2)"

PC305 Split Rail Fence
(updated June 5/2024)
Step 5 page 4 - Queen - change (34) 8" squares to (34) 13" squares
Step 5 page 4 - King - change (41) 8" squares to (41) 13" squares